John Lewis JLBIDW1202 Manuel d'utilisateur télécharger pdf (Page 27)

Insert the appliance after the adjustment of

the appliance level. When inserting the

appliance, ensure that the water inlet and

drain hoses are not kinked or squashed.

During all operations that involve

accessibility to internal components the

appliance must be unplugged.

Be sure that once the appliance has been

installed, it is easily accessible for the service

engineer in the event that a repair is

required.

Fixing to the adjacent

units

The appliance must be secured against

tilting.

Therefore make sure, that the counter it is

fixed under, is suitably secured to a fixed

structure (e.g. adjacent kitchen unit cabinets,

wall).

Water connection

Water inlet connection

This appliance must be connected to a cold

water supply.

For making the connection itself, the

coupling nut fitted to the appliance inlet hose

is designed to screw onto a 3/4" gas thread

spout or to a purpose made quick-coupling

tap such as the Press-block.

The water pressure must be within the limits

given in the ‘Technical data’. Your local

Water Authority will advise you on the

average mains pressure in your area.

The water inlet hose must not be kinked,

crushed, or entangled when it is being

connected.

The appliance features inlet and drain hoses

which can be turned either to the left or the

right to suit the installation by means of the

locknut. The locknut must be correctly fitted

to avoid water leaks.

If the appliance is connected to new pipes or

pipes which have not been used for a long

time, you should run the water for a few

minutes before connecting the inlet hose.

This appliance has been fitted with safety

features which will prevent the water used in

the appliance from returning back into the

drinking water system. This appliance

complies with the applicable plumbing

regulations.

Caution! Do not use inlet and drain

hoses which have previously been

used on another appliance.

Water drain connection

The end of the drain hose can be connected

in the following ways:

• To the sink outlet spigot, securing it to the

underside of the work surface. This will

prevent waste water from the sink

running into the appliance.

• To a stand pipe provided with venthole,

minimum internal diameter 4 cm.

27

1 2 ... 22 23 24 25 26 27 28 29 30 31 32

Commentaires sur ces manuels

Pas de commentaire