John-lewis JLBICM 01 Manuel d'utilisateur

JLBICM 01 Coffee machine Instruction manual

8 • Fix the U base plate inserting 4 self-threading screws into the 4 front holes of the same plate. Then screw the telescopic runners to e

9Technical specifications Width 594 mmDepth 475 mmHeight 378 mmCapacity of water reservoir 2.5 l Net weight 28 kg Gross weight 31 kg Supply v

10 The control panel 1. Water refill indicator 2. ON-OFF/stand-by indicator 3. Start indicator 4. Hot water selector indicator 5. St

11Instructions for the first use Filling up the water reservoir • Squeeze together the unlocking levers found under the drip t

12 • Remove the reservoir and fill it with approximately 2.5 litres of water as shown. • replace the water reservoir in

13Filling up the container with coffee beans • Press the unlocking levers located under the drip tray and pull the machine as

14 • Push the machine back into the housing until a „CLICK‰ can be heard. This indicate that the machine has been locked in position.

15Adjusting the texture ground coffee CAUTION This machine is calibrated in the factory for an optimum level of ground coffee. Too „coarse‰ ground

16 • Push the machine back into the housing until a „click‰ can be heard. This indicates that the machine is locked in position. Sta

17Making coffee • Press the control corresponding to the desired selection. • Press the start control within 10 seconds and the machine will

18 • The steam/water pipe can be moved to the back of the cabinet when not in use. Hot water Pull forward when required. CAUTION: when

19Steam - Heating liquids • The steam/water pipe can be moved to the back of the cabinet when not in use. Pull forward when required. CAUT

20 Programming the amount of coffee beans to be grinded • This espresso machine has already been calibrated in factory to dispense the ideal measu

21• Once you have modified the coffee ground quantity, press the start control for 10 seconds and the machine will automatically save the quantity

22 Programming the volume of coffee dispensed in the cup • The volume of coffee dispensed can be adjusted as desired as follows: • Press the e

23If you wish to reset the standard values Resetting standard values • This coffee machine is calibrated in the factory to make the optimum Itali

24 Signal and alarms Water refill indicator • This machine has a sensor which detects when the water reservoir is empty. • the reservoir empty

25Cleaning Outer parts • Clean the stainless steel parts of the machine with a soft cloth without using aggressive detergents. Never use any

26 Drip tray • Remove the drip tray from the machine as it is shown in the figures above. • Make sure that the drip tray is periodically draine

27 • Replace the drawer and close the door. Replace the drip tray. Water reservoir • If the machine is not used for long periods,

Important Safety Information It is most important that this instruction book should be retained with the appliance for future reference. Should the a

28 Repairs - after sales service If your coffee machine is not performing satisfactorily, consult the fault finding guide within this instruction

John Lewis Partnership 171 Victoria Street London SW I E 5NN www.johnlewis.com

During use For installation and servicing Keep this instruction manual together with the machine for any future reference. If the machine is sold or

3 Contents For the User For the Installer Important safety information 1Installation 5Description of the coffee machine 4• Building-in 5T

4 Description of the Appliance 1. Water reservoir 2. Brita filter 3. Coffee Outlet 4. Steam/water nozzle 5. Drip tray 6. Coffee beans

5Installation Building-in Installing the machine into kitchen furniture with proper characteristics will ensure a correct operation of the equipmen

6 • Unscrew the cable clamp available on the machine. • Fix the power cable onto the machine as shown in the figure.

7Installing the machine • Lay the U base plate of the machine on the shelf of the cabinet. • Insert the L plates, co